Hand Held Products 9550 - Manual (Page 24)

2 - 8 Dolphin® 9500/9550 Mobile Computer User’s Guide
Step 4. Initialize the Mobile Computer
1. When power is applied from a newly installed battery, the decode LED lights and the scan LED blinks for approximately three
seconds. Do NOT press any keys while the terminal is booting up.
2. The terminal initializes and the HHP splash screen displays for a few seconds. The Build numbers indicate the software
version number.
3. The system performs a hard reset. When the display activates again, follow the instructions that appear.
Step 5. Align the Screen
You are prompted to align the screen by tapping the target five times. Use the stylus provided by HHP.
• Alignment should always be performed with a stylus designed for touch screen applications. The small point is required for
accurate calibration.
• Press the stylus firmly into the center of the cross-hair target once and release. Do not “double-tap” the target.
• You can re-align the screen at any time by going to Start > Settings > System tab > Screen .
Step 6. Complete the Screens
After aligning the screen, follow the directions on the screen which take you through a simple exercise showing how to use the
stylus and pop-up menus.
Build: 5.XX/5.XX/5.XX
Bootloader
Kernel
Keyboard
Tap the target firmly and accurately at
each location on the screen. The target
will continue to move until the screen is
aligned.