Honeywell SC1000 - Manual (Page 90)

page 90 008-0608-00
previously entered as
KNOWN POINT 3/5
and
DISPLAY. UNITS
). When you have applied
this displacement to the transducer, press [ENTER].
• The display will read
WORKING
, then
APPLY 00750 UNIT
(where 00750 and UNIT are pre-
viously entered as
KNOWN POINT 4/5
and
DISPLAY. UNITS
). When you have applied this
displacement to the transducer, press [ENTER].
• The display will read
WORKING
, then
APPLY 01000 UNIT
(where 01000 and UNIT are pre-
viously entered as
KNOWN POINT 5/5
and
DISPLAY. UNITS
). When you have applied this
displacement to the transducer, press [ENTER].
• Upon completion, the display will indicate
DONE
and the instrument will return to the
RUN mode.