Honeywell SC1000 - Manual (Page 123)

SC Series Instruction Manual page 123
Re
la
y O
utp
ut Ch
annel
13
Chapter 13
Relay Output Channel
13.1 Features
13.1.1 First Channel
Installed
The first Relay Output channel installed in an instrument supplements the stan-
dard four limits (Limit 1, Limit 2, Limit 3 and Limit 4) . Its four, dry contact relay out-
puts will mirror the Limit Outputs pins of the System connector.
In the
SYSTEM
->
CONFIGURATION
sub-menu, channels of this type are identified as
LIMIT
01-04
.
13.1.2 Second Channel
Installed
The second Relay Output channel installed in an instrument adds another four
limits to the instrument (Limit 5, Limit 6, Limit 7 and Limit 8). Its relay outputs
show the status of these limits.
In the
SYSTEM
->
CONFIGURATION
sub-menu, channels of this type are identified as
LIMIT
05-08
.
13.1.3 Third Channel
Installed
The third Relay Output channel installed in an instrument adds another four limits
to the instrument (Limit 9, Limit 10, Limit 11 and Limit 12). Its relay outputs show
the status of these limits.
In the
SYSTEM
->
CONFIGURATION
sub-menu, channels of this type are identified as
LIMIT
09-12
.
13.1.4 Fourth Channel
Installed
The fourth Relay Output channel installed in an instrument adds another four lim-
its to the instrument (Limit 13, Limit 14, Limit 15 and Limit 16). Its relay outputs
show the status of these limits.
In the
SYSTEM
->
CONFIGURATION
sub-menu, channels of this type are identified as
LIMIT
13-16
.