Honeywell SC1000 - Manual (Page 151)

SC Series Instruction Manual page 151
Error Me
ssag
es
17
Chapter 17
Error Messages
17.1 Overview
If the instrument detects an error during the RUN, INITIALIZE, or SETUP modes,
it stops operation and enters its ERROR mode as described in “Operating Modes”
on page 19.
The most frequent causes of error messages are:
• Wiring/electrical connection problems
• Misplaced address jumpers when installing or removing channel circuit
boards
• Swapping channel circuit boards between instruments
• Incorrect calibration of the transducer to the instrument