Honeywell SC1000 - Manual (Page 51)

SC Series Instruction Manual page 51
Di
splay Menu
8
Chapter 8
Display Menu
8.1 Overview
The Display menu allows you to examine and change settings that affect the oper-
ation of the display of the SC instrument. You can change which channel is dis-
played when the instrument is powered-up and what information is shown on the
lower line of SC1000, SC2000 and SC2001 instruments.
Detailed instructions on operating the SC instrument in the SETUP Menu mode
can be found in “SETUP Menu mode” on page 23. A diagram of all menus is
located in the “Setup Menu Reference” on page 157.
8.2 Menu Items for Models SC1000, SC2000, SC2001
These instruments have a dual-line display which consists of an upper line and a
lower line.
8.2.1
UPPER CHANNEL
Menu
Item
Specifies the channel that is displayed on the upper line when the instrument is
powered-up.
To change whether the channel’s track, peak or valley data value is displayed on
power-up, use the channel’s “
OPERATION
->
POWER-ON SOURCE
” menu item.
8.2.2
LOWER CHANNEL
Menu
Item
Specifies the channel that is displayed on the lower line when the “
LOWER MODE
”
menu item is set to “
CHANNEL
”.
To change whether the channel’s track, peak or valley data value is displayed on
power-up, use the channel’s “
OPERATION
->
POWER-ON SOURCE
” menu item.
8.2.3
LOWER MODE
Menu
Item
Determines what is displayed on the lower line. The choices are:
• “
BLANK
” means that nothing is displayed.
• “
LIMIT 01-04
” means that the status of Limit 1, Limit 2, Limit 3, and Limit 4 are
displayed as described in “Indicator Lights” on page 21
• “
CHANNEL
” means that the channel specified with the “
LOWER CHANNEL
” menu item
is displayed.
8.2.4
DISPLAY DISABLE
Menu Item
Determines if the display is enabled or not. In some applications, the display is
not used in order to reduce power consumption; the instrument is then completely
controlled with the Serial Communications interface. The choices are:
• “
OFF
” means that the display operates normally.
• “
ON
” means that the display is blanked after the instrument is powered up.
Pressing any button on the front panel will temporarily re-enable the display
until the instrument is reset.
8.3 Menu Items for Model SC3004
8.3.1
POWER-ON CHANNEL
Menu Item
Specifies the channel that is selected when the instrument is powered up.
To change whether the channel’s track, peak or valley data value is displayed on
power-up, use the channel’s “
OPERATION
->
POWER-ON SOURCE
” menu item.