HONDA 08B21-SJC-102 - Manual (Page 16)

16 of 17
AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.
63. Slide the driver’s seat back and forth to check that
the rear camera subharness is not pulled too tight
or is too loose.
62. Plug the rear camera subharness 6-pin connector
into the Navi control unit.
61. Route the rear camera subharness along the
vehicle harness and under the floor carpet, then
pull the rear camera subharness out from under
the floor carpet opening under the driver’s seat.
Secure the rear camera subharness to the
vehicle harness with two wire ties.
60. Continue routing the rear camera subharness
forward along the vehicle harness, and secure
the subharness to the vehicle harness with four
small wire ties.
4712041K
FRONT
SMALL
WIRE
TIES
VEHICLE
HARNESS
REAR CAMERA
SUBHARNESS
DRIVER’S
SEAT
REAR CAMERA
SUB HARNESS
6-PIN CONNECTOR
NAVI
CONTROL
UNIT
4713030K
4713040K
DRIVER’S
SEAT
Check that the
rear camera
subharness is not
pulled too tight
when the seat is
moved back and
forth.
4N10010K
DRIVER’S
SEAT
VEHICLE
HARNESS
REAR CAMERA
SUBHARNESS
FLOOR CARPET
OPENING
WIRE
TIES
www.collegehillshonda.com