HONDA 08B21-SJC-102 - Manual (Page 2)

2 of 17
AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.
2 EPT sealers
4 Cushion tapes
2 Socket bolts, 4 x 10 mm
3 Washer screws, 4 x 12 mm
2 Washer screws, 4 x 6 mm
Rear camera
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
10 mm Combination wrench
Ratchet
10, 12 mm and 14 mm Socket
Torque wrench
File
Isopropyl alcohol
Shop towel
Tape measure
Drill
3 mm, 8 mm, and 10 mm Drill bits
Utility knife
T40, and T50 Torx bit
KTC trim tool
Scissors
Tape
Electrical tape
Wire
3 mm Hex wrench
Illustration of the Rear Camera Installed on the
Vehicle
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
1. Make sure you have the anti-theft code for the
radio, then write down radio station presets.
2. Disconnect the negative cable from the battery.
7 Clips
Round grommet
6 Oval grommets
Accessory user’s information manual
Rear Camera Kit (sold separately)
P/N: 08A57-SJC-100
4712100K
NAVI CONTROL UNIT
REAR CAMERA
SUBHARNESS
6-PIN CONNECTOR
REAR
CAMERA
GROMMET
www.collegehillshonda.com