HONDA 08B21-SJC-102 User Manual
Page 17
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
AII 36587 (0705)
17 of 17
64. Reconnect the negative cable to the battery. Turn
the key to the ON (II) position, and enter the Navi
code.
65. Move the shift knob to the “R” position.
66. Loosen the two 4 x 6 mm washer-screws. Adjust
the rear camera angle up or down so that the end
of the rear bumper is reflected at the lowest
possible end of the navigation monitor. Tighten
the two 4 x 6 mm washer-screws. Install the rear
camera trim to the rear camera bracket with two 4
x 10 mm socket bolts.
67. Turn the key to the off position.
68. Measure and mark the rear bumper at the location
shown.
71. Check that all wire harnesses are routed properly
and all connectors are plugged in.
72. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
73. Set the clock.
74. Check the operation of the rear camera according
to the owner’s manual provided.
75. Put the rear camera Owner’s Manual in the glove
box with the vehicle owner’s manual.
76. Reinstall all removed parts.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
77. Start the engine. Push down fully on the driver’s
window switch until the window is fully open.
78. Pull up fully on the driver’s window switch to close
the window completely, then hold the switch for
2 second or more.
79. Test the window AUTO function.
69. Using a utility knife, cut and remove measured
piece from the rear bumper. Remove any burrs
from the cut area with a file.
70. Reinstall the rear bumper.
4N15011K
REAR
BUMPER
Cut off.
10 mm
15 mm
3 mm
5D10060T
4 x 10 mm
SOCKET BOLTS
REAR CAMERA
TRIM
REAR
CAMERA
Adjust the angle.
REAR CAMERA
BRACKET
2 4 x 6 mm
WASHER SCREWS
www.collegehillshonda.com