Dimensions and clearances, Installation instructions, Positioning the range – Heartland Bakeware U109760-02 User Manual

Page 34

Advertising
background image

Read all instructions before installing or using this appliance.

Installation Instructions

Save these instructions for future reference.

U109760-02

34

Dimensions and clearances

Provide adequate clearances between the
range and adjacent combustible surfaces. These
dimensions must be met for safe use of your
range. The location of the electrical outlet and
pipe opening (see Gas Pipe and Electric Outlet
Locations) may be adjusted to meet specific
requirements.

Positioning the Range

The diagrams below show the minimum
recommended distance from the range to
nearby surfaces.

A Min 35

3

/

8

’’(89.8cm) Max 36

7

/

16

(92.5cm)

B Min 43

5/16

’’ (110cm) - 43

11/16

” (111cm)

recommend to allow for moving the range)
For Canada Min 44

5/16

” (112.5cm)

C Min 30’’ (76cm)
D Min 3’’ (7.5cm) but see below about door

opening.

E Min 50’’ (127cm)
F Min 18’’ (43cm)
G Maximum 13’’ (33cm)
The cooktop surround should be level with,
or above, any adjacent work surface. Above
cooktop level a gap of 3” should be left between
each side of the range and any adjacent vertical
surface.

For non-combustible surfaces (such as
unpainted metal or ceramic tiles) this can be
reduced to 1”.

A minimum space of 30” is required between the
top of the cooktop and a horizontal combustible
surface.

The maximum depth for cabinets installed above
cooktops is 13’’.

If the range is to be installed between 24’’ deep
cabinets the optional rear spacer should be fitted
to move the range 2’’ forward. See the spacer
fitting instruction section of these instructions.

Any range hood should be installed in
accordance with the hood manufacturer’s
instructions.

For safety reasons curtains must not be fitted
immediately behind the range.

We recommend a gap of 43-11/16” (111cm) (for
Canada 44-5/16” (112.5cm)) between units to
allow for moving the range.

If a flush fit is required (USA only), fit the range
up to the unit at one side then fit the unit the
other side.

A clearance of 5” (13cm) is required if the range
is near a corner of the kitchen to allow the oven
doors to open.

��

������

Advertising