Heartland Bakeware U109760-02 - Manual (Page 35)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
35 U109760-02
Location guidelines
Do not locate the range where it may be subject
to strong drafts. Any openings in the floor or wall
behind the range should be sealed. Make sure
the openings around the base of the range that
supply fresh air for combustion and ventilation
are not obstructed by carpeting or woodwork.
Your range is heavy and can settle into soft floor
coverings such as cushioned vinyl or carpeting.
Use care when moving the range on this type
of flooring. It is recommended that the following
simple and inexpensive instructions be followed
to protect your floor.
The range should be installed on a sheet of
plywood (or similar material). When the floor
covering ends at the front of the range, the area
that the range will rest on should be built up with
plywood to the same level or higher than the
floor covering.
This will allow the range to be moved for
cleaning or servicing. Also, make sure your
floor covering will withstand 180°F. (See the
Installation Safety Instructions section.)
Make sure the wall coverings around your
range can withstand the heat generated (up to
200°F) by the range. (See the Installation Safety
Instructions section.)
Moving the Range
The range is very heavy. Take great care.
We recommend two people maneuver the
range. Ensure that the floor covering is firmly
attached, or removed to prevent it being
disturbed when moving the range around. You
will need the leveling tool.
Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each
side) to release the catches holding the drawer
to the side runners and at the same time pull the
drawer forward and away from the side runners.
For safety’s sake push the drawer runners back
out of the way. Put the drawer somewhere safe
- do not refit it until you have completed the
installation, you will need access to the area
behind the drawer.
Fit the leveling tool on the rectangular adjuster
as shown below.
LOWER THE FRONT ROLLER by doing 14
complete (360°) turns clockwise. (This means
turning and removing the leveling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fit the leveling tool on the hexagonal
adjusting nut as shown below.
Make 10 complete (360°) turns clockwise. (This
means turning and removing the leveling tool 20
times).