Heartland Bakeware U109760-02 - Manual (Page 41)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
41 U109760-02
NOTE: Do not install the conduit without a
squeeze connector.
Fit the wires to the ground post and terminal
block
NOTE: Make sure the wires are completely
inserted into the terminals and secure
connections are made.
Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.
Refit the electrical connection cover.
Fitting a 3-Wire Power Cord
Disconnect the supplied power cord from
the terminal block and ground post. Keep
the terminal block parts; you will need them.
Remove the strain relief clamp from the power
cord and remove the power cord and strain relief
clamp from the mounting bracket. Discard the
strain relief clamp.
NOTE: Do not install the power cord without
a strain relief - use the clamp supplied
with the cord.
Fit the new strain relief device to the mounting
bracket by removing the two clamping screws,
feeding the two halves (ears first) through the
hole in the mounting bracket and loosely refitting
the screws. Insert the power cord through the
strain relief device but do not tighten the device
yet.
A Ground strap is supplied in the conversion
pack.
ground strap.
Fit the Ground strap to the ground and center
terminal of the connector block - see the figure.
The neutral or ground wire of the power cord
must be connected to the neutral terminal
located in the center of the connector block. The