Heartland Bakeware U109760-02 - Manual (Page 37)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
37 U109760-02
Leveling the Range
Place the range in its intended position taking
care not to twist it within the gap between the
kitchen units as damage may occur to the range
or the units. Install the oven shelves in the oven.
Check for levelness by placing a spirit level or
a cup, partially filled with water, on one of the
oven grids. If using a spirit level, take two
readings-with the level placed diagonally first in
one direction and then the other.
The rollers can be adjusted to level the range.
To adjust the height of the rear of the range use
the leveling tool supplied to turn the adjusting
nuts at the front bottom corners of the range.
Adjust the height of the front roller to level the
range. Turn clockwise to raise the range and
counter clockwise to lower.
When you are satisfied with the height and level
raise the front of the range by one turn of the
front roller adjuster. Screw down the front feet
to meet the floor. Screw the front roller adjuster
counter clockwise to raise the front roller so
that the front of the range is supported on the
feet, not the front roller, to prevent accidental
movement of the range.
Leave the leveling tool in the storage drawer,
so that the customer can use it if they wish
to move the range.
Anti-Tip Device
WARNING
Range must be secured by Anti-Tip bracket
supplied. See instructions to install (supplied
with bracket). Unless properly installed, the
range could be tipped by leaning on the door.
Injury might result from spilled hot liquids or from
the range itself.
Installing the Anti-Tip Device
The Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
Gas Connection
Installation of this range must conform with local
codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1-latest
edition.
In Canada the range must be installed in
accordance with the current CGA Standard CAN/
CGA-B149 - Installation Codes for Gas Burning
Appliances and Equipment and/or local codes.
In The Commonwealth Of Massachusetts
This product must be installed by a licensed
plumber or gas fitter when installed within the
Commonwealth of Massachusetts.
A manual valve must be installed in an accessible
location in the gas piping, external to the appliance
for the purpose of turning on or shutting off the gas
supply.
Gas Supply Requirements
Recommended Gas Pipe Outlet Locations
Opening inside the drawer cavity
Provide Adequate Gas Supply