Honeywell HRDPX - Manual (Page 32)

Setup
______________________________________________________________________________________________
32
Disk Configuration
Format
Shows installed Hard Disk Drives and the status of other attached storage
devices.
To format a Hard Drive use the arrow keys to select the appropriate device and
press ENTER. Select OK to confirm formatting and press ENTER.
To format a USB device use the arrow keys to select USB FORMAT and press
ENTER. Select the USB target and select FAT32. Press OK to format.
Tip Refer to the list of Approved USB Flash Drives in the Introduction
chapter.
To refresh the list of connected USB devices select USB RESET and press
ENTER.
Caution All USB devices must be formatted as FAT32 before using with the
DVR.
Note Upon formatting a drive, all video and other data stored on that drive
will be permanently erased and cannot be recovered.