Handspring 90 - Manual (Page 155)

Chapter 8 Page 155
Conducting a modem HotSync operation
You can use a modem to synchronize your handheld when you are away from your computer. The
modem can be located on an expansion card, or inside a mobile phone that you connect to your
handheld.
Note: The first HotSync operation must be local, using the cable. After that, you can perform a
modem HotSync operation.
To perform a modem HotSync operation you must complete the following steps:
■ Connect a modem to your computer
■ Configure HotSync Manager for use with your modem
■ Connect a modem to your handheld
■ Configure the Modem Preferences on your handheld for use with your modem
Preparing your computer
There are a few steps you must perform to prepare your computer for a modem HotSync
operation. Be sure to perform these steps before you leave your office so that your computer is
ready to receive a call from your handheld.
To prepare your computer for a modem HotSync operation:
1. Confirm that the computer modem is connected and turned on, and that no communications
applications, such as fax or telephony software, are running.
Note: Make sure the computer is disconnected from all online services, such as America
Online (AOL) and CompuServe. This helps to avoid port conflicts.
2. Open Palm Desktop software.
3. From the HotSync menu, choose Setup.
4. On the HotSync Controls tab, make sure that HotSync is Enabled.
5. Click the Serial Port Settings tab.
6. Under Check for handheld connection using, select Modem Setup.
7. Under Modem Setup, adjust the following options as needed: