Honeywell HRTL-One - Manual (Page 21)

Rev 1.00 10 Document 900.0259
10/04
Installation
P
Rear Panel Connections
Figure 2-6 shows the rear panel connections and Table 2-2 describes the connections.
Figure 2-6 Rear Panel Connections
VIDEO IN
POWER
VIDEO OUT
ALARM
Table 2-2 Rear Panel Connections to Peripheral Equipment
Connection Description
1. Video In Connect to video source (for example, a quad, multiplexer, or
camera).
2. Video Out Connect to a monitor if there is no quad or multiplexer in your
system (see
Figure 2-4 ).
Connect to the video input of a quad or multiplexer, as shown
in
Figure 2-5 .
3. External
I/O
• RS-232 / RS-485 front panel command line interface
Controlled remotely by an external device or control
system (see
Figure 2-4 ).
• Multiplexer synchronization
• Disk full indication
• Record enable/disable
• Video loss indication
• Alarm input/output
4. Power Connect to power cable.