Honeywell HRTL-One - Manual (Page 39)

HRTL-One Digital Video Recorder User Guide
Rev 1.00 29 Document 900.0259
10/04
P
Remote Protocol Setup
You can control the HRTL-One remotely using commands specified in Table 3-6 . On the
Remote screen you configure:
• Remote protocol interface
• Transmission baudrate
• Remote protocol ID
1. On the Main Menu screen, press S or T to select Remote, then press Enter.
The following screen appears:
Figure 3-9 Remote Screen
2. Press S or T to select the Remote Mode field, then press Enter.
Press S or T to choose from the following options:
RS-232 = RS-232 interface
RS-485 = RS-485 interface
Press Menu to confirm your changes.
3. Press S or T to select the Baud Rate field, then press Enter.
Press S or T to choose from the following options:
115200, 57600, 19200, 9600, 4800, 3600, 2400, 1200
Press Menu to confirm your changes.
4. Press S or T to select the ID field, then press Enter.
Press S or T to set the numerical number and press W or X to move to the next
digit (3 digits).
Press Menu to confirm your changes.
5. Press Menu to exit this screen and confirm the current operations.
6. If you have completed all your system configuration changes, press Menu again to
exit and close menu setup.
(Remote)
Remote Mode: RS-232
Baud Rate: 9600
ID: 000
(Menu)
Timer
Record
Alarm
Remote
System
Event
J
J