Honeywell HRTL-One - Manual (Page 42)

Rev 1.00 33 Document 900.0259
10/04
4
Operation
After you set up your system, you are ready for day-to-day operation. This chapter
describes how to use the HRTL-One DVR to:
• Record video
• Play video clips
• Search for video clips
Figure 4-1 Front Panel Controls
Control Function
MENU Press to enter menu setup and enter the Administrator password (default is 0000) to access the
Main Menu.
ENTER Press to accept changes that you make in menu setup.
SEARCH Press to search for previously recorded video.
SLOW Press to slow down the speed of Play mode.
STOP Press to stop recording or playing.
REC Press to start recording.
Note Pressing REC will put the system in manual recording mode, overriding any timed
recording configured in the menu setup.
POWER Press to power up the HRTL-One. Press again to power off the HRTL-One.
REW
(Left) Press once to play video backward at high speed. Press again to adjust the speed (1X, 2X, 4X,
8X, 16X, 32X, depending on the number of times you press this button).
FF
(Right) Press once to play video forward at high speed. Press again to adjust the speed (1X, 2X, 4X, 8X,
16X, 32X, depending on the number of times you press this button).
PAUSE Press to pause the video at the currently displayed image.
PLAY Press to play recorded video.
HDD HDD Full ALARM TIMER PLAY REC
MENU ENTER SEARCH SLOW
POWER REC
PAUSE / Up
REW
Left
STOP / Down
FF
Right