HP WP36/50 - Manual (Page 108)

Appendix B Host Computer Interface
B-6
The Properties sheet is displayed for the selected
COM
port. Click on the Port Settings tab and set the
port properties.
Figure B-4
After setting the properties, click the OK button.
■ ■ ■ ■ DOS
Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
5
6
1
2