HP WP36/50 - Manual (Page 43)

Chapter 3 Using the Operator Panel
3-22
Press the MENU key.
Press the or key repeatedly until Interface >
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until Network ap-
pears.
Press the ENTER key again. The question mark (?)
disappears
Press the key and then press the or key re-
peatedly until the message display indicates
>Network Status Page.
The default setting is On. If it is set to Off, change it
as follows. Press the ENTER key. A blinking question
mark (?) appears.
Select On using the or key.
Press the ENTER key again.
Press the MENU key. The message display returns to
Ready.
Network Status Page
Figure 3-8
2.2.5 Changing the Emulation
The emulation mode for the current interface can be changed.
Press the MENU key.
Press the or key repeatedly until Emulation
appears. One of the emulation names shown below
appears, indicating the current emulation.
PCL 6 (default)
KC-GL
KPDL
KPDL (AUTO)
Line Printer
IBM Proprinter
DIABLO 630
EPSON LQ-850
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until the desired
emulation mode appears.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Interface >
Parallel
Interface
?Parallel
Interface
?Network
Interface >
Network
>Network Status
Page On
>Network Status
Page ? On
>Network Status
Page ? Off
>Network Status
Page Off
1
2
3
4
5
6
7
8
9
Emulation
?PCL 6
10
NETWORK STATUS PAGE
1
2
3
4
5
6