HP WP36/50 - Manual (Page 67)

Chapter 3 Using the Operator Panel
3-46
Press the MENU key.
Press the or key repeatedly until Paper
Handling > appears.
Press the key. >Stitch Adjust > appears.
Press the key. >>A4/Letter appears.
Press the or key to select A4/Letter, B4 or
A3/Ledger.
When the desired paper size is displayed, press the ENTER
key. A blinking cursor (_) appears under the value.
Press the or key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the
and keys to move the cursor right and left.
Definable value: -057 to 057
When the desired value is displayed, press the
ENTER
key.
Press the MENU key. The message display returns to
Ready.
Overriding A4 and Letter Size Difference
This selects whether to enable or disable the difference be-
tween A4 size and Letter size. Under the default setting of
Off, the paper size of the paper source is matched to the pa-
per size formatting the jobs. If these differ, a corresponding er-
ror message is displayed. When this is set to On, printing is
performed even if the actual paper size differs from the paper
size formatting the jobs.
Press the MENU key.
Press the or key repeatedly until Paper
Handling > appears.
Press the key.
Press the or key repeatedly until >Override
A4/LT appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Customizing Paper Type
The following describes the procedure used to set a user-de-
fined paper type for the printer. Eight custom user settings
may be registered. After having been set, any of these may
be called up when setting the paper type for a paper source.
The paper weight and duplex path can be set (see Setting the
Paper Weight on page 3-47 , and Setting the Duplex Path on
page 3-47 ) after selecting the paper type to be customized as
follows. For how to reset the customized settings, see
Resetting the Type Adjust on page 3-47 .
Press the MENU key.
Press the or key repeatedly until Paper
Handling > appears.
Press the key.
Press the or key repeatedly until >Type
Adjust > appears.
Paper Handling >
>Stitch Adjust >
>>A4/Letter
000
>>A4/Letter
000
Paper Handling >
1
2
3
4
5
6
7
8
9
1
2
>Override A4/LT
Off
>Override A4/LT
? Off
Paper Handling >
>Type Adjust >
Custom 1
3
4
5
6
7
8
1
2
3
4