Using memory cards, Inserting and removing a memory card, 7 using memory cards – HP 9100 series User Manual
Page 79: Inserting and removing a memory, Card
ENWW
Inserting and removing a memory card 77
7
Using memory cards
The all-in-one comes with a memory card reader that can read several types of digital camera
memory cards. You can use the all-in-one to save, print, or e-mail photos from these memory
cards. You can also print a proof sheet, which shows thumbnail views of photos that are stored
on a memory card.
The network administrator can choose to restrict photo mode use. When the feature is
restricted, inserting a memory card or pressing P
HOTO
sounds a beep, and the following
message appears:
Photo card has been disabled. Check with administrator
.
Note
On Macintosh computers, the Photo Save button still appears in the HP photo and imaging
software when photo mode use has been restricted. However, clicking the button causes the
all-in-one to stop operating. If this happens, quit the program.
This section contains information about the following topics.
z
Inserting and removing a memory card
z
z
Viewing and editing image files
z
Sending photos as e-mail attachments
z
z
Inserting and removing a memory card
You can use only one memory card in the all-in-one at a time. The all-in-one does not operate
if you insert more than one memory card in the slots.
CAUTION
Do not insert or remove memory cards when the light on the memory card reader is blinking.
Doing so can damage the all-in-one, the memory card, or the information on the memory card.
You can safely remove the card when the light next to the slots remains on or is not blinking.
To insert a memory card
Insert the memory card into the appropriate slot so that the edge with the connectors (holes)
goes inside the all-in-one. Inserting the card incorrectly can bend the pins inside the slots or
otherwise damage the mechanism that reads the memory cards.