Heartland Bakeware 3800-3820 - Manual (Page 12)

9
Clearances
• Minimum distance between the cooktop and a side wall above the cooktop surface is 6”
(see dim "J" in Table 2 on next page)
• 0” Clearance to the back of the cooktop may be obtained when installing the appliance against a non - combustible wall or
with the installation of our Splashback Kit. Responsibility for ensuring that the rear wall is non - combustible lies with the
owner or end user. (check local building codes) - if wall behind cooktop is deemed combustible and our splashback kit is
not installed, then the minimum spacing from the back of stove to nearest combustible wall is 6”
• Depth of cutout must not exceed 25”. (see dimension G) Air intake slots on underside of control panel must not be
obstructed
or covered.
Electrical requirements:
• Electrical hookup must be done by a licenced electrician
• 120 Volts 60Hz .375 kW 3 prong plug 5 ft-(1.5 m) power cord included.
Gas Requirements:
• Gas hook-up must be done by a licensed gas fitter.
• Pressure requirements: Natural gas: 6” W.C. (min); LP gas: 11” W.C. (min)
• Connection: 1/2” NPT
• An accessible manual shut off valve must be installed at the appliance.
• Note: This unit contains a pre-set regulator.
• Natural Gas/Propane Conversion kits are available - must be done by a licensed gas fitter
Figure 1
Dim 36" Metro Cooktop
A 26 5/8" (68cm)
B 8 1/4" (21cm)
C 36" (91cm)
D 1
Standard profile:12 3/4" (32 cm)
(as shown in diagram)
D 2 low profile: 10 1/8" (26 cm)
D 3
high back w/ shelf:
28 1/4" (72cm)
Table 1
B
C
Installation Diagram- 36” Metro CooktopModel 3825
Air intake slots on underside
of control panel must not be
obstructed or covered.