HP 403349-003 - Manual (Page 34)

Removal and replacement procedures 34
3. Lift the air deflector plate up, tilt it to an angle, and pull it out toward you.
To replace this component, see "Replacing the air deflector plate (on page 34 )."
Replacing the air deflector plate
1. Reattach the ground bonding wires to the air deflector plate.
2. Align the two screw holes on the air deflector plate to the two screw holes inside the MCS unit.
3. Secure the air deflector plate to the MCS unit by tightening the two thumbscrews in the two screw
holes.
Air sealing plate
The air sealing plate is not a spare part. The removal and replacement instructions for the air sealing
plate are provided so that you can access other components.