HP 403349-003 - Manual (Page 50)

Removal and replacement procedures 50
2. Connect the two sensor connectors to the condensation pump.
3. Connect the AC power cable to the condensation pump.
4. Replace the air sealing plate (" Replacing the air sealing plate " on page 36 ).
5. Relocate the power inlet box back into position (" Relocating the power inlet box back into position "
on page 95 ).
6. Replace the bottom fan unit (" Replacing the bottom fan unit " on page 45 ).
7. Complete the operation checklist (on page 111 ).
Fan unit
The three fan units are located at the rear of the MCS unit.