HP StudioJet - Manual (Page 38)

40 Ioline FlexJet E User Guide
Printing to the Floor
With careful setup and constant supervision, the printer will print
markers directly onto the floor. This method is NOT intended for
printing long markers or unattended printing.
1.
Thread the paper on the front of the machine. It should drape
off the platen, over the feed roll, and onto the floor.
2. Set an origin normally and begin plotting. Make sure that the
paper piles smoothly onto the floor. If it bunches up, it may
catch on the moving carriage and tear.
If the paper bubbles or
wrinkles while it flows
over the platen surface,
the carriage might catch the edge
of the paper and tear it, causing
a paper jam. Make sure that the
paper is smoothly collecting on
the floor to avoid paper jams.
Caution
The front dancer bar should not be
used when plotting to the floor.
Note
i