HP StudioJet - Manual (Page 39)

Cleaning the Drive Shaft
Clean the drive shaft
regularly to assure ac-
curate plotting:
1.
Turn off the print-
er and disconnect
the power cord.
2. Gently remove
any accumulated
dust and residue
with the stiff non-
metal bristle brush
provided in the
Accessory Kit .
Cleaning the Platen and Traverse
Dust and paper residue accumulate on the platen and traverse. Un-
der regular use, clean every two weeks:
1.
Turn off power to the printer.
2. Dampen a lint-free cloth with isopropyl (pharmacy) alcohol
and gently wipe
traverse rails until
accumulated resi-
due is removed.
3. Use a lint-free
cloth dampened
with de-ionized
water to clean ink
splatters off the
platen and excess
ink out of the Ser-
vice Station waste
well.
Do not pray the printer
with water, solvents or
other liquids. Use a non-
metal bristle brush or a cloth
dampened with water or isopro-
pyl alcohol. Keep the drive shaft
bearings free of all liquids.
Caution
Use antistatic spray to clean
platen and traverse, if desired.
Hint
Chapter 4
Routine Maintenance
Figure 27. Cleaning the Drive Shaft.
Figure 28. The Service Station