Harbor Freight Tools METAL CUTTING BANDSAW 93762 - Manual (Page 11)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 11
to attach the pulley cover:
pulleY
cover (72)
worm
shaFt (9)
motor
shaFt (81)
bodY
Frame (60)
heX bolt (76)
Flat washer (77)
Figure d
Position the Pulley Cover (72) over
the Worm Shaft (9) and Motor Shaft
(81). Align the mounting hole in the
Pulley Cover with the mounting hole
in the Body Frame (60). Then secure
the Pulley Cover to the Bandsaw,
using one Hex Bolt (76) and one Flat
Washer (77). (see Figure d.)
to attach the spindle pulley and motor
pulley:
motor pulleY (79)
shaFt KeY (80)
(not shown)
spindle pulleY (1)
v-belt (10)
Figure e
1. Slide the Spindle Pulley (1) fully onto
the Worm Shaft (9). Then secure the
Spindle Pulley to the Worm Shaft,
using one Socket Head Screw (2).
(see Figure e.)
Insert the Shaft Key (80) in the slot 2.
on the Motor Shaft (81). Align the
slot in the Motor Pulley (79) with
the Shaft Key. Slide the Motor Pul-
ley fully onto the Motor Shaft. Then
secure the Motor Pulley to the Motor
Shaft, using one Socket Head Screw
(2). (see Figure e.)
to install the v-belt:
Figure F
heX bolt (70)
motor (81)
The V-Belt (10) can be installed by
loosening the Hex Bolt (70) and mov-
ing the Motor (81) forward. Place the
V-Belt around the top grooves in the
Spindle Pulley (1) and Motor Pulley
(79). Next, move the Motor back-
wards to tighten the tension on the
V-Belt. Then, re-tighten the Hex Bolt
to secure the Motor in place.
(see Figures e and F.)
to adjust the cutting speed:
The Bandsaw is designed to cut at 1.
three different speeds: 80, 120, and
200 Fpm (Feet Per Minute) depend-
ing on the type of material being cut.