Harbor Freight Tools METAL CUTTING BANDSAW 93762 User Manual
Page 20
SKU 93762
For technical questions, please call 1-800-444-3353.
Page 20
Blade into the workpiece.
(see Fig-
ure t.)
10.
warning! Keep hands and
fingers safely away from the cut-
ting area.
Slowly lower the Body Frame (60),
11.
while it gradually feeds the Saw
Blade (82) into the workpiece. Do not
force the Bandsaw to remove mate-
rial faster than it is designed to cut.
(see Figure t.)
Never attempt to remove mate-
12.
rial stuck in the moving parts of the
Bandsaw while it is plugged in and
running. Turn off the Bandsaw if the
workpiece is to be backed out of an
uncompleted cut.
important:
13.
When in the horizontal
cutting mode only, the Switch Push-
Off Tip (41) will automatically turn
the Power Switch (164) to its
“oFF”
position and shut off the Bandsaw’s
Motor when the cut has been com-
pleted.
(see Figure t.)
Once the cut is made, check to make
14.
sure the Power Switch (164) is in its
“oFF” position. Then, unplug the
Power Cord Plug from its electrical
outlet.
(see Figure t.)
Wait until the Saw Blade (82) comes to
15.
a complete stop. Next, raise the Body
Frame (60) to its full vertical position,
making sure it locks in place by turn-
ing the Support Plate (150) to the right
until it firmly locks into the Body Frame.
Remove the workpiece from the Vise
assembly (138, 141) and scrap mate-
rial from the Machine Bed (142) of the
Bandsaw. Then, slowly lower the Body
Frame (60) to its horizontal position
and lock it in place with the Locking Pin
(115).
(see Figure t.)