Harbor Freight Tools METAL CUTTING BANDSAW 93762 User Manual
Page 23
SKU 93762
For technical questions, please call 1-800-444-3353.
Page 23
to lubricate the worm gear and
5.
worm shaft: The Worm Gear (17)
and Gear Shaft (19) run in an oil bath
Gear Box and should not require an
oil change more than once a year,
unless the oil becomes contaminated
or a leak occurs due to improper
replacement of the Gear Box Cover
(14). To change oil in the Gear Box:
Position the Body Frame (60) in the
a.
horizontal position.
(see Figure s.)
gear boX
cover (14)
heX
bolt (11)
worm
gear (17)
gear shaFt
(19)
Figure w
b. Remove the four Hex Bolts (11),
Gear Box Cover (14), and Gear Box
Gasket (15).
(see Figure w.)
Remove the old oil from inside the
c.
Gear Box and replace the oil us-
ing 140 weight gear oil. The new
oil should just come to the edge of
the Gear Box. Do not overfill.
(see
Figure w.)
Replace the Gear Box Gasket (15),
d.
Gear Box Cover (14), and four Hex
Bolts (11).
(see Figure w.)
to clean the exterior parts of the
6.
bandsaw, use only a clean cloth
and mild detergent or mild solvent to
clean the body of the Saw.
do not
immerse any electrical part of the
machine in any liquids.
Figure X
pivot (120)
locKing pin (115)
7.
when the bandsaw is not in use or
when transporting the tool: Al-
ways lower the Body Frame (60) to
its horizontal position and insert the
Locking Pin (115) into the Pivot (120)
to secure the Body Frame in place.
(see Figure X.)
8.
caution! all maintenance,
service, or repairs not mentioned
in this manual must only be per-
formed by a qualified service tech-
nician.