Harbor Freight Tools METAL CUTTING BANDSAW 93762 - Manual (Page 8)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 8
Improper connection of the equip- 3.
ment-grounding conductor can re-
sult in a risk of electric shock. The
conductor with insulation having an
outer surface that is green with or
without yellow stripes is the equip-
ment-grounding conductor. If repair
or replacement of the electric cord or
plug is necessary, do not connect the
equipment-grounding conductor to a
live terminal.
Check with a qualified electrician or
4.
service personnel if the grounding
instructions are not completely under-
stood, or if in doubt as to whether the
tool is properly grounded.
Use only 3-wire extension cords that
5.
have 3-prong grounding plugs and
3-pole receptacles that accept the
tool’s plug.
Repair or replace damaged or worn
6.
cord immediately.
7. This tool is intended for use on a cir-
cuit that has an outlet that looks like
the one illustrated above in 125 v~
3-prong plug and outlet. The tool
has a grounding plug that looks like
the plug illustrated above in 125 v~
3-prong plug and outlet.
The outlet must be properly installed 8.
and grounded in accordance with all
codes and ordinances.
Do not use an adapter to connect this
9.
tool to a different outlet.
double insulated tools: tools
with two prong plugs
To reduce the risk of electric shock, 1.
double insulated equipment has a po-
larized plug (one blade is wider than
the other). This plug will fit in a polar-
ized outlet only one way. If the plug
does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact
a qualified electrician to install the
proper outlet. Do not change the plug
in any way.
Double insulated tools may be used
2.
in either of the 120 volt outlets shown
in the preceding illustration. (see
outlets for 2-prong plug.)