Harbor Freight Tools METAL CUTTING BANDSAW 93762 - Manual (Page 16)

SKU 93762 For technical questions, please call 1-800-444-3353. Page 16
ing the Locking Pin (153).
(see Figure h.)
Turn on the Bandsaw. The Saw
2.
Blade (82) is tracking properly when
the back of the Blade is just touch-
ing the edge of the Blade Wheel (37)
flange. The back of the Blade should
not be rubbing against the flange.
(see Figure p.)
If adjustment is necessary, the Blade
3.
Guide Bearings (88, 92, 100, 104)
should be clear of the Saw Blade
(82). (see Figure n.)
heX bolt (21)
lower screw (22)
blade tension
adjusting Knob
(34)
blade wheel
(37)
Figure o
4. Loosen the middle Hex Bolt (21) to a
point where it is loose but snug.
(see Figure o.)
With the Bandsaw running, turn the
5.
lower Screw (22) until the Saw Blade
(82) is tracking properly, making sure
Blade tension is maintained by turn-
ing the Blade Tension Adjusting Knob
(34). (see Figure o.)
Re-tighten the middle Hex Bolt (21) 6.
when adjustment is complete.
(see Figure o.)
adjusting the blade tension:
blade tension
adjusting Knob (34)
blade
wheel (37)
blade
wheel (54)
saw
blade
(82)
blade
bacK
cover
(114)
Figure p
1. Turn the Blade Tension Adjusting
Knob (34) clockwise to increase ten-
sion on the Saw Blade (82). Turn the
Blade Tension Adjusting Knob coun-
terclockwise to decrease tension on
the Saw Blade. Correct tension is
acquired when the Saw Blade is just
tight enough so that no slippage oc-
curs between the Saw Blade and the
Blade Wheels (37, 54).
(see Figure p.)