HP 240 Series - Manual (Page 40)

hp photosmart 240 series
chapter 5
36
4 Select from the following options:
– Always if you want the printer to discard the existing photo selections
and print settings after printing.
– Never if you want the printer to keep the existing photo selections and
print settings for further printing.
– Ask if you want the printer to ask each time it prints whether you want
to keep the existing photo selections and print settings for further
printing.
5 With your selection highlighted on the printer’s LCD screen, press the OK
button.
default number of copies
You can set the printer to print up to 99 copies of each photo. The printer’s
factory default setting is one copy. You can change the default setting by
following these steps:
1
Press the M
ENU
button on the printer’s control panel.
2 Press the S
ELECT
P
HOTOS
 button until Preferences is highlighted on the
printer’s LCD screen. Press the OK button.
3 Press the S
ELECT
P
HOTOS
 button until # of copies is highlighted on the
printer’s LCD screen. Press the OK button.
4 Press the S
ELECT
P
HOTOS
 button to increase the default number of
copies, or press the S ELECT P HOTOS  button to decrease the default
number of copies. Press the OK button.
Note: This default setting applies every time you print. To override the
default setting and print a different number of copies of a photo, display the
photo on the printer’s LCD screen and press the C
OPIES
button. The changed
number of copies applies to the displayed photo only.
default photo layout
You can set the printer to print one, two, or four photos per page, or to ask you
to select the photo layout each time you insert a memory card into the printer’s
memory card slot. The printer’s factory default setting is to Ask you to select the
photo layout each time you insert a memory card. You can change the default
setting by following these steps:
Note: If you change the default photo layout to either one, two, or four
photos per page, you will not see the Select Layout screen when you insert
a memory card into the printer’s memory card slot.
1 Press the M ENU button on the printer’s control panel.
2 Press the S
ELECT
P
HOTOS
 button until Preferences is highlighted on the
printer’s LCD screen. Press the OK button.
3 Press the S
ELECT
P
HOTOS
 button until Photo layout is highlighted on the
printer’s LCD screen. Press the OK button.