HONDA Outboard Motor BF150A - Manual (Page 70)

68
SERVICING YOUR OUTBOARD MOTOR
IGNITION COIL SPARK PLUG COVER
BOLTS WIRE CONNECTOR
BOLT
Do not try to remove the mud guard
clip with f orce without raising the
inner part of the mud guard clip.
Otherwise, it can damage the mud
guard clip and/or under cover.
Remove the two bolts with the 6
mm hex wrench, and remove the
spark plug cover.
Remove the two mud guard clips
from the upper part of the under
cover grommet.
Fold down the upper part of the
under cover grommet without
removing it from the idle port.
To remove the mud guard clips,
raise the inner part of each mud
guard clip with a screwdriver, then
pull out the clips.
Use a 6 mm hex. wrench to
remove the bolt holding the
ignition coil. Move the ignition
coil to a position that allows
removal of the wire connector
easily.
Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
5. 6.
7.
3.
4.
05/02/22 14:35:41 31ZY6600_069