HP 7200 - Manual (Page 214)

3. Locate the cover on the bottom, and then follow the steps below to unlock the print cartridge
cradle.
a.
Use the tab to rotate the cover 1/4 turn in either direction.
b. Remove the cover. This exposes a gear that controls the height of the print cartridge
cradle.
c. Rotate the gear toward the back of the device until it stops.
Note You will rotate the gear a number of times before it stops.
4. Open the print-carriage access door, and then remove the print cartridges from their slots
and lower the latches.
Note Remove both print cartridges and lower both latches. Failure to do so might
damage your HP All-in-One.
5. Place the print cartridges in an airtight plastic container (or print cartridge protectors if
available) so they will not dry out, and put them aside. Do not send them with the HP All-in-
One unless the HP customer support call agent instructs you to.
6. Rotate the gear toward the front of the HP All-in-One until it stops.
This locks and secures the print cartridge cradle for safe shipment.
7. Reattach the cover to the bottom of the HP All-in-One by aligning the two tabs directly
across from each other on the cover with the whole slots. With the cover in position rotate it
1/4 turn to lock the cover in its place.
8. See Remove the control panel overlay and pack your HP All-in-One to complete preparation
for shipment.
User Guide 211
G
et HP
support