Hitachi SA200 - Manual (Page 102)

B Using the BIOS Setup Program
90 SA200
Note: If the system determines that the hard disk drive is 528MB or
larger (unformatted capacity), it automatically “sees” the hard disk
drive using LBA mode. If you are using a 528MB or larger hard disk
drive from an older system that does not support LBA mode, the
system cannot read it properly. You must reconfigure the BIOS
Setup program and reformat the hard disk drive.
CD-ROM/ATAPI Device
Press Enter to access the CD-ROM/ATAPI Device submenu. This
submenu shows the ATAPI device installed in the peripheral bay
and is automatically determined by the computer. The options are:
•
None
•
CD-ROM
•
ATAPI Removable
The default value for this field is: CD-ROM
Boot Sequence
Press Enter to access the Boot Sequence submenu. Using the
<+><-> keys, select the order of the drives that you want the
system to go through during the boot-up process. The options are:
•
Removable Device
•
CD-ROM Drive
•
Hard Drive
The Auto option may provide a different set of
parameters for the same hard disk drive at
different times. You should, however, always
reconfigure the hard disk drive with the
parameters you received the first time. If you use
a different set of parameters, you may be unable
to read any data on the hard disk drive. Be sure
to record the original configuration parameters
for your hard disk drive for future use.
lonestar.boo : sa200.fm Page 90 Friday, March 6, 1998 10:53 AM