HP 2420 - Manual (Page 223)

Print Task Quick Sets
Use the Print Task Quick Sets control to store the current combination of driver settings that appear
on all other Printing Preferences driver tabs. Print task quick sets are either preset or user-defined
printing specifications, such as media size and pages per sheet. For more information, see the
Paper/
Quality tab features section of this guide.
Status group box
The unlabeled group box on the Job Storage tab contains a status message about the destination of
a print job. The status information changes depending on the selections that are made on the Job
Storage tab.
Job Storage Mode
Use the Job Storage Mode options on the HP LaserJet 2410, 2420, and 2430 printer to store
documents at the product and then control their printing at the product control panel. This feature is
intended to provide greater flexibility, convenience, security, and cost savings.
The HP LaserJet 2410, 2420, and 2430 printer offers the following Job Storage Mode options:
■ Off
■ Proof and Hold
■ Private Job
These options and the settings that control them are described below.
Off
When selected, this option turns the Job Storage feature off (it is disabled), which means that the
print job will not be stored in the product.
Proof and Hold
To use the Proof and Hold option, Job Storage must be enabled, and the product must have a
minimum total memory of 80 MB.
When selected, this option stores the print job in memory and prints only the first copy of the job,
allowing you to check the first copy. If the document prints correctly, you can print the remaining
copies of the print job at the control panel. You can set the number of proof-and-hold print jobs that
can be stored in the product at the control panel.
After it is released for printing, the proof-and-hold job is immediately deleted from the product. If
more copies are needed, you must reprint the job from the software program. Proof-and-hold jobs
are deleted if you turn off the product.
NOTE The product configuration can be set to hold a maximum of 50 proof-and-hold jobs.
The number is set at the product control panel in the CONFIGURATION menu, and the
default is 32. When this preset limit is reached, the new document overwrites the oldest held
document.
HP PCL 6, HP PCL 5e, and PS emulation unidriver features 207
HP unidrivers