Hypertec ISDN 10T Router - Manual (Page 47)

Configura
40
Figure 0-8, Internet PPP Window
Remote Router Name
The remote router name is the name assigned to the remote router located at the ISP end. Any visible
ASCII characters are acceptable. The remote router name is not required when you want to dial into your
ISP’s point of presence. In general, your ISP assigns to you a remote IP address for administration
purpose.
Compression
The compression field specifies if the Stac compression protocol will be turned on for the Internet
connection.
Encapsulation Protocol
The encapsulation protocol field specifies the protocol you want to run as the link protocol. Select PPP if
you want to run single channel PPP. Select MLPPP if you intend to run two channel PPP when traffic
becomes heavy.
Dial-out Authentication
The dial-out authentication field specifies which protocol you want to run as the PPP/MLPPP
authentication protocol when you initiate an ISDN call to your ISP. Most ISPs support PAP and CHAP
protocols.
Dial-out Password
The dial-out password specifies the password to use during the dial-out authentication process. This field
is case sensitive, and is given to you by your ISP.