Harman Stove Company P43 - Manual (Page 5)

5 P43 Pellet Stove
assembly and installation
unpacking
The P43 is bolted (1/4 x 1" hex head bolts) to the
skid to prevent movement during shipping.
To free the stove from the skid you must remove
the hold-down bolts in the rear of the pedestal
base.
removing rear cover panels
The rear cover panels are secured to the stove
with three bolts each. Two ot the bolts need
only be loosened, not removed, to remove the
panels. It is recommended that the rear covers
are installed after the unit is in place and the vent
pipe is installed, to prevent contact with hot or
moving parts.
Firebrick
Install the firebrick horizontally on the angle
bracket above the burnpot.
Flame guide
Install the cast iron flame guide on top of the
burn pot. Make sure that the flame guide is fully
seated on the vertical sides of the burn pot and
that the back of the guide rests against the body
of the stove.
INSTALL EXHAUST VENT AT CLEARANCES
SPECIFIED BY THE MANUFACTURER. Most
pellet vent pipe requires a minimum of 3" of
clearance to combustible materials allthough
some can be installed at 1" clearance.
Rear Cover
Panels
Shipping Bolts
Note: These same holes
are used for securing the
stove in mobile home
installation.
Fig. 1