Hitachi Koki USA DDC 35n - Manual (Page 130)

6.3 Running Telnet
6-40
T
C
P/IP
Co
nfig
ur
ati
o
n
Cha
p
ter 6
4. To end your Telnet session, type E at the Main Menu. If you have
made any changes you are prompted to either Save Changes and
Exit or Exit Without Saving Changes. Choose your option and
press .
Note
6.3.2 Configure IP Parameters
Although the NIC must have an IP address before a Telnet Connection
can be made, you can use the utility to change the address or the other
IP parameters. The NIC will automatically initiate a soft reset when the
IP address change is sensed.
Note
1. At the Main Menu, type 1 and press to bring up the IP
Parameters menu (shown on the next page).
The Configuration Utility
Unit Serial no. 460121 V5.04
Main Menu
1. IP Parameters
2. LPD Printers
3. Protocols
4. Reset Unit
5. Restore Factory Defaults
6. Change Password
E. Exit
• Press ? to access the Telnet help utility.
• This will cause the Telnet connection to be broken. It is advisable to
make all other desired changes before changing the IP address.
Enter
Enter