Hitachi Koki USA DDC 35n - Manual (Page 36)

2.3 Connecting to a Network the NIC
2-2
Ins
tal
ling t
he N
e
twor
k
In
ter
fac
e Ca
rd
Ch
apt
er
2
2.3 Connecting to a Network the NIC
Use an RJ45 connector (10/100BaseT) or BNC connector (10Base2) to
connect to an Ethernet.
1. Turn off the printer.
2. Connect the connector to the NIC.
3. After you make the connection, perform the procedure under 2.2
Powering Up the Printer.
Note
• Use a Category 5 cable when connecting with a 10/100BaseT.
• Be sure to use a cable with a ferrite core when making a 10/
100BaseT connection.
10/100BaseT:
Plug an RJ45 connector into the
10/100BaseT port on the back of
the NIC. Attach the ferrite core so
that it is near the connector. Next,
secure the ferrite core so that it
cannot move out of position using
the tie band.
10Base2:
Use a BNC T adapter to connect
to the BNC connector on the back
of the NIC.
Feritecore
Tie band