Hitachi Koki USA DDC 35n - Manual (Page 166)

C.1 Accessing the HTTP Server Screens
C-4
Usi
ng
a W
eb B
rows
e
r
A
ppen
di
x C
Important!
C.1.1.1 Reset
Use this screen when you need to reset the NIC to allow newly set
parameter values to take effect.
Note that resetting the NIC fully initializes the network interface,
without initializing the interface with the printer.
C.1.1.2 Factory Defaults
Use this screen when you need to restore the factory defaults when
you move the NIC to a new location or to clear incorrect settings.
Note
C.1.1.3 Unit Status
This screen shows the status of each protocol.
C.1.1.4 Network Address
The serial number of the unit as well as the MAC Address can be
confirmed from this screen.
C.1.1.5 Change Password
The password you specify here is the one you type in before
changing NIC parameters and printer settings.
• To change network settings you must first type the correct password
(same as the management password) in the password field provided.
• Clicking a button to execute a network setting change operation while
the wrong password is in the password field causes the password error
screen to appear, without changing the setting.
• Settings made will not be recognized by the printer until the power to
the printer is turned off and then on again.