Other product information, Fcc statement – Handspring Visor User Manual

Page 275

Advertising
background image

Page 275

Other Product Information

Limited Warranty and
End User Software License Agreement

For warranty information and a copy of the End User License Agreement applicable to
your Handspring product, please see the Handspring web site at http://www.hand-
spring.com/support/ug_warranties.jhtml. If you would like a copy of these materials
mailed to you, or if you have any questions, please contact Handspring Customer Sup-
port.

The information included on this web site sets forth Handspring's sole and complete
warranty and software licensing obligations with respect to your Handspring product.
Use of the product indicates your acceptance of the terms of the warranty and the End
User License Agreement.

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

Note:

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

The use of shielded I/O cables is required when connecting this equipment to any and
all optional peripheral or host devices. Failure to do so may violate FCC rules.

Caution:

Changes or modifications not covered in this manual must be approved
in writing by the manufacturer’s Regulatory Engineering Department.
Changes or modifications made without written approval may void the
user’s authority to operate this equipment.

Advertising