Hearth and Home Technologies CASTLEWOOD 42 - Manual (Page 20)

Outdoor Lifestyles by Hearth & Home Technologies Inc. • 4070-300 Rev D • 11/11 20
E. Mortar (Optional)
The non-combustible finishing
material across the top of
fireplace opening will be even
with lower edge of metal face.
Non-combustible finishing
materials MUST overlap
side faces by 1 1/4 in. (32 mm)
to cover the edges of the
panels. Finished opening
should be 38 x 42 in. (965 x
1067 mm) to allow for door
installation.
If Mortor is applied, it should be
applied after finishing material is
installed. Mortar will be applied
between finishing materials and
molded brick edges, bottom and
sides.
The seam between finishing materials
and firebox top must be sealed with
non-combustible sealant.
The surface of the finished hearth extension and
the surface of the hearth panel should be level.
Figure 7.5 Facing Materials and Mortar
The brick panels have been designed for installa-
tion without the use of mortar being necessary. If the
look of mortar is preferred, it is available and can be
installed. Follow the directions on the container for mix-
ing.
The mortar can be applied with a mortar bag or trowled
on. Applying with mortar bag may be easiest and less
messy. Clean sparingly as paint will rub off and may
need to be touched up. Touch up paint is available as
an accessory.
veRy ImpoRtANt: Allow the mortar 72 hours to cure before operating the fireplace.
D. Install Screens
• Lay one screen panel flat and slide the round end of
the rod through the rings starting at the handle side of
the screen. Leave the last ring off the rod.
• Insert the rod through the hole in the bracket. Slip the
last ring over the rod on the other side of the bracket.
• Fasten the flat end of the screen rod back in place us-
ing the screw removed earlier.
• Repeat for the other screen panel
Center of Fireplace Opening
Round end of Rod through rings,
then into Screen Rod Clip
Rod Screen
Clip
Inside
Firebox
Top of Fireplace
• Install the grate If a gas log set
is not going to be installed.
• Position the rear grate bar in the
Grate Retainer
• Position the top of the grate
retainer over the rear grate bar
and fasten in place with screw
provided.
F. Grate