Hearth and Home Technologies CASTLEWOOD 42 - Manual (Page 6)

Outdoor Lifestyles by Hearth & Home Technologies Inc. • 4070-300 Rev D • 11/11 6
F. Grate
This fireplace is designed to be used with the grate sup-
plied with this unit or one approved by HHT. The grate will
deteriorate over time and will need occasional replace-
ment.
Warning! Risk of Fire!
Use only the factory-supplied intergral grate.
Keep logs in place.
Allows proper air circulation around the fire.
G. Firescreen
The firescreen is provided to control sparks. Keep it
closed when the fireplace is in use
.
WARNING!
Risk of Fire or Burns
!
SCReeN WIll Not pReveNt BuRNING mAteRIAlS FRom
FAllING out.
SCReeN pullS oR hANdleS mAy Be hot .
H. Cooling Air
Cooling air is necessary to install the fireplace on a com-
bustible surface and in a combustilbe enclosure. Two inlet
hoods are provided and must be installled, to allow cooling
air to be drawn into the enclosure. Ducting between the
hoods and the fireplace is not necessary.
The complete structure must be noncombustible if the hoods
are not installed.
I. Molded Brick Panel
• The molded brick panels are shipped separately, but
required to contain heat and provide an attractive interior.
• They will deteriorate over time and will need occasional
replacement. Small hairline cracks and discoloration are
normal and do not affect safety.
• Mortar is not necessary but can be used to enhance the
appearance.
E. Inspect Fireplace and Components
Fire Risk
Explosion Risk
Inspect fireplace and components for
damage. Damaged parts may impair safe
operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components
WARNING
• Carefully remove the fireplace and components from the
packaging.
The fireplace system consists of the following:
• Fireplace / Integral grate/dual cooling air inlet hoods,
firescreen, and hearth refractory.