Document Outline

• 1. Introduction
  • What is a HIB-IP?
    • Available Models
    • HIB-IP 8000 vs. Legacy HIB-IP Units
      • HIB-IP versus EXB-IP
      • HIB-IP 8000 Software Support
  • Reference Documents
  • Front Panel
    • MCN Network Note 1
    • MCN Network Note 2
    • Front Panel Indicators – Additional Information
  • Rear Panel
    • 10Base-T Warning
    • Option Switch Settings
    • HTTP Page Security Note
• MCN NETWORK Connections
• RESET Button
• Buttons for use with Custom Configuration Press only when requested.
• CSVC Button Identifies Control Processor
• Ethernet Connector
• DC IN Input Power This powers only this unit. Power is not passed to the Network Out connector.
• OPTION Switches
• 2. IP Address Configuration
  • MCN Config Software
  • IP Settings Worksheet
  • Backup & Restore Procedures
  • Security and Information Assurance Recommendations
• 3. Installation
  • Physically Install HIB-IP Unit onto the IP Network
    • A) Set Option Switches:
      • Less restrictive security:
    • B) Mount the HIB-IP units (See Appendix B for Mounting Option details):
      • Desk, Wall, or Rack Mounting
    • C) Make electrical connections (See Appendix C for connector details):
      • Grounding
      • DC Power Connection
    • C) Program IP Parameters:
    • D) Connect to the MCN & IP networks:
      • MCN Network Connection
      • Ethernet Connection
      • IP Switch Manual Settings Note
    • E. Run the MCNRCD program or the MCN Server program:
• 4. Testing
  • HTTP Status Page
    • Additional System Security & HTTP Page
  • Pinging the HIB-IP Unit
• Appendix
  • Appendix A. Factory Default Configuration
    • Control Processor
      • Restoring Factory Default Communication Parameters
      • IP Address Parameters
  • Appendix B. Mounting Options
    • Rack Mount Option
    • Wall Mount Option
  • Appendix C. Connector Details
    • DC IN Connector
    • NETWORK Connectors
      • RJ45 Connectors:
      • 2-Position Screw-Terminal:
    • Ethernet Connectors
      • 10BaseT Connector: AUI Connector (early versions) Note: This connector removed on later versions
    • ASYNC Serial Programming Connector
  • Appendix D. HIB-IP Programming Cable Pinout 89-11314
    • Programming Cable Warning
  • Appendix E. Troubleshooting
    • Table E1
    • Table E2
    • Table E3
    • Table E4
    • Table E5
    • Table E6
  • Appendix F. Specifications
    • HIB-IP
  • Appendix G. IP Addressing
    • Conventions
    • IP Address Classes
      • Subnetting using Subnet Masks
      • Summary of Important Networking Details
    • MAC Addresses
    • Address Resolution Protocol (ARP)
    • Ethernet 10BaseT Cables
    • Auto-MDIX
    • IP Switch Configuration – Speed & HDX/FDX Negotiation
  • Appendix H. HIB-IP Firmware Notes
    • Regents of the University of California License
  • Appendix I. Regulatory Notes
• Index