Appendix, Appendix a. factory default configuration, Control processor – CTI Products HIB-IP IP Interface User Manual
Page 19: Restoring factory default communication parameters, Ip address parameters, Ppendix, Actory, Efault, Onfiguration
CTI Products, Inc.
HIB-IP & HIB-IP 8000 Hardware Reference Manual
Appendix A. Factory Default Settings
19
A
PPENDIX
A
PPENDIX
A.
F
ACTORY
D
EFAULT
C
ONFIGURATION
Control Processor
Restoring Factory Default Communication Parameters
If the Control Processor communication parameters are overwritten so that the HIB-IP cannot communicate
with the MCN Network, they can be restored as follows:
• Press the “RESET” button on the front of the HIB-IP unit
• After the “ERR” LED goes off, press the “RESET” button a second time.
The Control Processor communication parameters are now restored to factory defaults.
IP Address Parameters
The units are factory programmed as follows:
• IP Address:
192.1.1.1
• IP Address Mode:
Unicast
• Subnet Mask:
255.255.255.0
• PC IP Address
192.1.1.201