CTI Products HIB-IP IP Interface - Manual (Page 20)

CTI Products, Inc. HIB-IP & HIB-IP 8000 Hardware Reference Manual
Appendix B. Mounting Options 20
A PPENDIX B. M OUNTING O PTIONS
Wall mount and EIA 19” rack mount kits are available as options for the HIB-IP units from CTI Products, Inc.
The wall mount kit includes brackets to allow a single HIB-IP module to be mounted to any flat surface. The
rack mount kit includes an adapter allowing up to three HIB-IP modules to be mounted in a single rack unit
height.
Rack Mount Option
The rack mount option allows up to three HIB-IP modules to be mounted in a one rack unit height (1.75 inches)
of a standard 19 inch rack. The modules are mounted in the rack plate by removing its’ front bezel and
remounting the module into the rack plate. Figure 5 shows an exploded view of the rack mount installation.
The top diagram shows the front view of the bracket with one module installed. The bottom two diagrams show
a side view of the module installation into the rack adapter and rack adapter installation into the rack,
respectively.
CA-80374-100
FACEPLATE
SPACER
1 2 3 4
5
9 8 7 6
ERR
ACT PWR
RESET
WINK
ETH RX ETH TX
CSVC RSVC
NETWORK OUT IN
ASYNC
NETWORK
NCB NETWORK COMBINER
Figure 5 HIB-IP Module Rack Mounting