Document Outline

• Introduction
• Understanding the Basics
• Integrating the Scanner With Your Host System
  • Changing Interfaces
    • Hardware
    • Software
  • Customizing Your Scanner’s Operation
• Programming Overview
  • What Is Programming Mode?
  • Programming Session
    • Programming Sequence
• LED and Beeper Indicators
  • LED Indicators
  • The Beeper
• If You Make a Mistake...
  • Return to Factory Settings
• Where To Go From Here
• Interface Selection
  • Wand Emulation Interface
  • Wand Emulation Settings
    • Wand Emulation Pre/ Post-Noise Settings
  • RS-232 Interface/WN-RS-232 (SNI) Interface
  • RS-232 Communication Parameters
    • Baud Rate
    • Data Format Settings
    • Handshaking
    • RS-232 ACK/ NAK Options
    • RS-232 Intercharacter Delay
  • Keyboard Wedge Interface
    • PC Keyboard Wedge Interface Selection
    • Connect to a Laptop/No Keyboard Attached
    • Caps Lock
    • Country Mode
    • Keyboard Wedge Intercharacter Delay
    • Quiet Interval
    • Universal Wedge Terminal Selection
    • Terminal/ Keyboard Settings
    • Universal Wedge Number Pad
  • IBM Interface
    • Transmit Labels in Code 39 Format
• Label Transmit Configuration (RS-232 and Keyboard Wedge Interfaces only)
  • Prefix, Suffix, and Label I.D.
    • Setting Global Prefix(es)
    • Setting Global Suffix(es)
    • Single Character Prefix or Suffix
    • Disabling Prefix or Suffix
    • Setting Label I.D.
    • Label Identifiers
    • Setting Label I.D. Location
    • Setting Label I.D. by Symbology
    • Label I.D. Symbology Selection
    • Setting Single Character Label I.D.
    • Disabling Label I.D. for a Specific Symbology
• Symbologies Supported
  • Symbology Overview
  • Symbology Selection
• Symbology Options
  • Code 39/PharmaCode 39
    • Code 39 Options
    • Configuring the Code 39 Options
    • PharmaCode 39 Options
    • Configuring the PharmaCode 39 Options
  • Code128 and UCC/EAN 128 Options
    • Configuring the Code 128/ and UCC/EAN 128 Options
  • Interleaved 2 of 5 Options
    • Configuring the Interleaved 2 of 5 Options
  • Codabar Options
    • Configuring the Codabar Options
  • UPC/EAN Options
    • Configuring the UPC/EAN Options
  • Code 93 Options
    • Configuring the Code 93 Options
  • Standard 2 of 5/IATA Options
    • Configuring the Standard 2 of 5 Options
  • IATA
  • MSI/Plessey Options
    • Configuring the MSI / Plessey Options
• General Features
  • Programming the General Features
    • Green LED Lamp Idle State
    • Beeper Settings
    • Marker Beam Settings
    • AutoSense® Stand Mode
    • Low Power Mode
    • Low Power Shut-down Delay
    • Half-Angle
    • Multiple Read Mode
• Appendix A: Additional Information
  • RS-232 Host Commands
  • Need More Information?
• Appendix B: Sample Bar Codes
• Appendix C: Keypad
• ASCII Character Set