Oregon PowerScan Handheld Laser Scanner - Manual (Page 68)

62
PowerScan
®
Scanner
Symbologies Supported
Symbology selection (bar code type) determines which symbologies
the scanner will decode. The chart below shows the symbologies that
are supported by each interface. Once you have identified the symbolo-
gies you wish to enable, turn to the following pages, enable those sym-
bologies and set the data format options (e.g. check digit, start/stop
characters) required by your host system for each symbology type.
You must enable the symbology format options settings that are com-
patible with your host system.
The factory settings for each interface were chosen to meet the stan-
dard industry requirements and in most cases you will not need to
change the symbology format settings. If you are unsure of your sys-
tem requirements, test the scanner using the factory settings before
making any changes.
SYMBOLOGIES SUPPORTED
Code 39/Phar
maCode
Code128 EAN 128 Inter
lea
ved 2 of 5
Codabar UPC-A & E, EAN-13 & 8 UPC/EAN w/P2 Add-ons UPC/EAN w P5 Add-ons UPC/EAN w/C128 Add-ons Code 93 Standard 2 of 5/IA
TA
MSI/Plesse
y
INTERFACE TYPE
RS-232-STD
WN*-RS-232
Wand Emulation
Keyboard Wedge
(all subtypes)
IBM Port 5B
IBM Port 9B
IBM Port 17
IBM Port E
= Supports this symbology
*Wincor Nixdorf