Oregon PowerScan Handheld Laser Scanner - Manual (Page 19)

Programming Guide
13
Where To Go From Here
Programming is easy and straightforward if you follow these steps:
1. If you are changing the scanner’s interface type, follow the
instructions in the section titled,
Changing Interfaces on page 2
before proceeding.
2. Scan any feature bar codes that are unique to the interface you
are currently programming. These interface specific program-
ming bar codes immediately follow each interface selection
label.
3. Turn to Symbologies Supported on page 62 if you are going to
change any bar code symbologies or modify any symbology-
related features.
4. Turn to General Features on page 132 if you wish to change or
modify any of the scanner’s other features.
Once the necessary changes have been made, and you have scanned
the END bar code, you are ready to scan.
NOTE
If you are changing some interface types (for
example; if you are moving the scanner from a
Universal Keyboard Wedge to an RS-232 host)
you must first change the hardware. Replace
the scanner’s interface board (if required) and
connect the scanner using the new interface
cable BEFORE performing any programming
changes.